Home One in Progress

Home One parts printed at 140%.

The larger rear pod is hollow and will allow lighting, but it looks like holes will need to be drilled manually to run wires between the pod and main ship. The smaller pod in the front has no openings for lighting. I may experiment with printing it with a slice removed to allow access since it will only be displayed in the docked position.

This is by far my favorite connection system. The separate connector (shown in place on the left) forms a very good light trap to prevent internal lighting from shining through the seams.

Trying to show the raised details on the surface. I think this really helps breakup printer artifacts, and I am a fan of all the surface shadows that this creates.