Community 
es 
ua 
USS Enterprise NCC 1701-D
USS Enterprise NCC 1701-D
Enterprise-D at Warp!
Separated Drive Section
Separated Drive Section
Docked!
On Display
On Display
On Display
On Display
Deflector Dish & Neck
Power Shot!
Deflector Dish & Neck at Night
1:700 Enterprise D vs. 5'-9" scratch built Titanic
1:700 Enterprise D vs. 5'-9" scratch built Titanic. This is a great shot to gauge the size and scale of this Enterprise Model. The ottoman it sits on, is nearly 4' long.
This project took four months from start to finish, and every step shows it. The ship was printed at 1:700 scale on a Creality CR10-S using eSun PLA filament. It houses two 5V rechargeable batteries, one each for the Saucer and Drive sections, so the lights stay on even after the saucer separates from the drive section. Every detail was painted by hand, with no decals or stencils. I would definitely recommend this build for any Star Trek TNG fans!
This project took four months from start to finish, and every step shows it. The ship was printed at 1:700 scale on a Creality CR10-S using eSun PLA filament. It houses two 5V rechargeable batteries, one each for the Saucer and Drive sections, so the lights stay on even after the saucer separates from the drive section. Every detail was painted by hand, with no decals or stencils. I would definitely recommend this build for any Star Trek TNG fans!
FFF/FDM printing: Creality CR-10
PLA (eSun Gray)
Printing time: 2.5 months
Painting time: 1.5 months
10 November 2026
0
0
